Aqua Lung Kronos Specifikace Strana 22

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 57
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 21
Buyer's Guide 2007
Sea Quest BCs
Sea Quest i3 from Aqua Lung
The Sea Quest i3 is an innovative, new infl ation system found exclusively in Sea Quest BCs. Its greatest asset is its simplicity
and how intuitive it is to use. Move the lever up to go up; push it down to go down. What could be easier? What’s more, when
dumping air from the BC, the i3 opens all of the new Flat E-Valves at once. Gone are the days of deciding which valve to reach for
based upon your orientation in the water.
Safe
The i3 allows you to take control of your diving. Mastering
buoyancy control is one of the most diffi cult skills to learn.
The i3 not only makes the skill easier but eliminates potential
out-of-control-ascents caused by a diver reaching for the
wrong dump valve. The i3 also allows for rapid location and
activation of the infl ator to establish buoyancy at the surface
in case of an emergency.
Easy
The i3 is simple and intuitive. Move the lever up to go up;
down to go down
Convenient
Unlike a traditional infl ator at the end of a fl oppy hose, the i3
never moves. It is stationary at the same location where your
left hand normally rests. It is always in the right place at the
right time.
Reliable
The i3 does not utilize pneumatics or hydraulics to activate the Flat E-Valves. Therefore, there is no possibility of
failure due to leaks. Using push-rod technology, as found in aircraft, the design remains simple and robust.
Fun
The i3 is just plain fun to use.
i3
Intuitive design makes buoyancy control safer and easier
Opens upper and lower dump valves simultaneously. No more thinking about which dump valve to reach for
Over-molded lever prevents gloves from slipping off while using
• Increased ow rate over traditional infl ators. Allows you to fi ll your BC faster
Attached dust cap prevents contaminants from entering mechanism when not in use
The i3 uses fewer parts and is easier to service compared to standard infl ators
Using the new lp hose grip, the lp hose can be attached or removed while wearing the BC.
This will satisfy instructional agency requirements to disconnect and reattach lp hose while training
Flat E-Valves
Extremely low profi le reduces drag in the water
Utilize a one-way valve to prevent water from back fl ushing in when all of the valves open at once
Very easy to service
Activated with push-rod technology making them very responsive
22
Zobrazit stránku 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 56 57

Komentáře k této Příručce

Žádné komentáře