Aqua Lung Kronos Servisní příručka stáhnout pdf (Strana 6)

6 Service Manual Kronos 2nd Stage

12. Using a screwdriver (111399) unscrew the seat

(AP2033). Push the tool (116236) inside the insert and

push the seat out. Remove the O-ring (444243).

13. Left up the edge of the exhaust valve and check that the

surface is clean and free from any scratches. It should

be flexible and have a clean contour. If it is in good

condition it is not necessary to remove it and it can be

reused. If it shows any signs of deterioration it should be

removed.

END OF DISASSEMBLY

Before starting to re-assemble the regulator,

make sure that all replacement parts have

been cleaned and lubricated in accordance

with Procedure A : Cleaning and Lubricating

on page 13

RE-ASSEMBLY PROCEDURE

1. If the exhaust valve has been removed, pass the valve

tail through the hole in the casing (from the outside) and

pull the tail lightly into the casing. If it is a new valve, cut

off any excess length leaving about 5mm.

2. Fit a new lubricated O-ring (444243) on the

seat(AP2033). Screw the seat into the insert (127605)

with the tool (127686).

3. Fit the insert into the casing (127617) by turning it 1/4

turn anti-clockwise. Once the insert is correctly

positioned, fit a new lubricated O-ring (124706) then

screw in the exchanger (127606) using a 11/16’’

spanner.

4. Fit a new lubricated O-ring (AP2041) on the shuttle valve

(AP2036). Fit the valve seat (AP2034). Lubricate the O-

ring (AP2041) correctly.

1 2 3 4 5 6 7 8 9 10 11 ... 18 19

Žádné komentáře

Aqua Lung Kronos Servisní příručka Strana 6