Aqua Lung Titan LX Servisní příručka stáhnout pdf (Strana 8)

14. With the flat side of the casing at eye level, screw in the

adjusting knob until the lever is about 4mm below the

level of the casing edge. Now unscrew it until the lever

just shows above the edge of the casing.

15. Using a 4mm Allen key tighten the adjusting screw one

turn for Supreme models and ¾ turn for other models.

16. Fit a new lubricated O-ring on the threaded end of the

hose. Fit a new lubricated O-ring on the hose nipple.

18.

Fit the diaphragm (13) in the casing. Press all around

the edges with a finger to ensure that it is in place. Fit

the washer (14) directly in contact with the diaphragm..

19.

After tightening the diaphragm retainer (15), hold the top

of the diaphragm and gently pull it in all directions to

ensure that it is firmly in place in the housing. If not, refit

it.

20. Fit the Legend or LX purge button making sure that the

name plate is the right way up. While holding the purge

button screw the ring fully home. Tight slightly the outer

ring with the wrench( P/N 129198)

21. Checking the venturi

21.1 Place the venturi control in the “ + “ position.

21.2 Press on the purge button. The regulator should free

flow.

While the regulator is free flowing, move the control to

the “ – “ position. The free flow should stop immediately.

If it does not stop, screw the seta in 1/8 turn and try

again.

20.1

22. Turn off the air supply and purge the second stage.

Tighten nut (5) using a 11/16” torque wrench at 0.5

Manually screw the

diaphragm retainer

(15) fully home, flat

face toward the

diaphragm. Use tool

(129001) to tighten it

an additional ¼ turn.

The spring pins for the

Titan and Legend are

different in shape.

Put the regulator under

pressure. Slide tool

(129001) along the top

edge of the casing. In the

highest position the tool

should press on the

lever, causing an airflow.

In the lowest position the

stage should not leak

air. Adjust the seat using

the tool until the

adjustment is correct.

Put at + and purge

Put at – to stop free flow

17.

Lever adjustment: Connect

the tool (122046) to the

second stage and the MP

hose to the tool. Connect

this assembly to a Legend

first stage adjusted as

follows:

Titan LX, Legend : MP = 9.5b

Titan LX Suprême, Legend

Supreme : MP = 8.5 b

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 21 22

Komentáře k této Příručce

Žádné komentáře

Aqua Lung Titan LX Servisní příručka Strana 8

Komentáře k této Příručce

Související produkty a manuály pro Potápěčské ploutve Aqua Lung Titan LX